Applications of Infrared Detectors

A pyroelectric detector with its high long-term stability can be used for accurate measurements of infrared radiation. As a thermal detector, it possesses (unlike semiconductor detectors) a very broad spectral sensitivity from 100 nm to about 1,000 µm and requires no cooling. Pyroelectric detectors are powerful thermal infrared detectors that can measure signals up to the kilohertz range. Short pulses can be detected up to a few microseconds.

The most common use of pyroelectric detectors is for motion detection. Inexpensive pyroelectric ceramic sensors generally suffice for this purpose. Other applications include the non-dispersive infrared gas analysis (NDIR gas analysis) and infrared flame sensing and monitoring. In these areas, mainly high-quality, single-crystal lithium tantalate (LiTaO3) is used as a pyroelectric material. This also gives a long-term stable performance for the large signal-to-noise ratio.

The use of pyroelectric detectors for spectroscopy or radiometry is also possible.

Application Examples

  • NDIR gas analysis in medical technology, measurement of anesthetic gases, capnography, breath alcohol testing
  • NDIR gas analysis in safety technology for industry and mining
  • NDIR gas analysis for process monitoring
  • Flame sensing and monitoring
  • Contactless temperature measurement
  • Measurement of radiation strength from deep ultraviolet to the far infrared radiation in the terahertz range

See for yourself the possibilities that InfraTec offers with its powerful, highly stable and high quality pyroelectric infrared detectors for your application.

  • Pyroelectric Detectors in the NDIR Gas Analysis - Picture credits: Juergen Faelchle @ Fotolia.com

    Gas Analysis

    The range of applications of pyroelectric detectors for gas analysis is very extensive, ranging from environmental measurements to the detection of gas leaks, steel analysis and medical patient monitoring while under anesthesia.
  • Infrared Flame Sensor / Infrared Flame Monitoring - Picture credits: TTStudio @ Fotolia.com

    Infrared Flame Sensor

    Use InfraTec’s fail-safe and consistently stable pyroelectric detectors for detecting typical spectral radiation, which is caused by burning organic substances.
  • NDIR Spectroscopy

    NDIR Spectroscopy

    In spectroscopes, very special pyroelectric detectors by InfraTec are used. Essential for this application are the uniform absorption characteristics over a wide wavelength range. This is made possible by a special absorption layer on the pyroelectric chip.



Picture credits: © Jürgen Fälchle/Fotolia.com, © TTstudio/Fotolia.com

Contact

InfraTec GmbH
Infrarotsensorik und Messtechnik
Gostritzer Str. 61 - 63
01217 Dresden 


workPhone:+49 351 871-8625
Fax:+49 351 871-8727 

E-Mail: 

InfraTec-TUEV-Seal